Dam Liners

Fabricated in Dam tough.

All sizes can be manufactured to specification.

Installation in 3 easy steps.
1. Mark the ground where you want the edge of the water to be. Mark another line 30cm outside the water edge. Measure the length and width of the outer line, add 150cm to both measurements. That gives you the size liner you require.

2. Dig a hole about 60cm deep to the inside line. Dig a step outside the first hole ot the outer line about 20cm deep. Lay a minimum 1cm sand on base of pond. Lay the liner in the hole and make pleats to allow the liner to lay flat.

3. Place a rocks, soil and plants over the liner on the step to hold the liner in place. Trim the liner where necessary. To get the full life from the liner you must cover the edge of the liner completely. Then fill the pond.